SRX Services Gateway
Highlighted
SRX Services Gateway

Access to the SRX 240H mnagement panel

2 weeks ago

Hi, I'm new to the forum and just getting started with the SRX 240H. I have started a dynamic VPN and now, after entering the public address on which this firewall is installed, I have a welcome message to log in to download the VPN client (probably called Phase 1) - screenshot attached


But I wish I could - either via VPN - or directly after entering the public address where this firewall is installed - to enter the management panel. Is it possible ?
Because even when I configure a VPN tunnel and get to the LAN, after entering gw, for example 192.168.2.1 - instead of the login panel, I see the VPN login screen.
Can you tell me what I'm doing wrong?

Attachments

1 REPLY 1
Highlighted
SRX Services Gateway
Solution
Accepted by topic author RobertM80
2 weeks ago

Re: Access to the SRX 240H mnagement panel

2 weeks ago

Hi Robert,

 

After you configured Dynamic VPN in SRX240H, you were no longer able to use the J-Web(GUI) on this device. Am I right? Please correct me if I'm wrong.

 

If above is your case, then it is an expected behaviour. Both Dynamic VPN and J-Web uses port 443 which is HTTPS. So, if you would like to access J-Web on the same 443 port, you gotta use something like this - set system services web-management management-url /mgmt

 

Use can use "/mgmt" or "/admin" or whatever suffix you want. Now when you access the J-Web via browser, you need to enter - https://192.168.2.1/mgmt

 

For more information, please refer to the following KB article - https://kb.juniper.net/InfoCenter/index?page=content&id=KB33505

 

Alternatively, you can also use J-Web to listen on a different port if you don't want to use the above method.

e.g.:

set system services web-management https system-generated-certificate

set system services web-management https interface ge-0/0/0.0 port 8443

 



Thanks,
π00bm@$t€®.
Please, Mark My Solution Accepted if it Helped, Kudos are Appreciated too!!!
Feedback